Absolute Acoustics NDS-UHM Series, Инструкция по установке

Страница: 21 / 30

NDS-UHM
Device Op erat io n
MA NUA L OPERATION
UHM matrix switchers can be controlled in several ways, either manually or integrated to a control system. This section describes the
functions available for each form of control, as well as a brief description of how to perform them.
To sw it c h an Inp ut t o a sing le O ut p ut :
1.
Press the button corresponding to the Input;
2.
Press the button corresponding to the Output;
Press ENTER to con rm the operation.
3.
To cancel the operation anytime, press the CLEAR button.
To sw it c h an Inp ut t o m ult ip le O ut p ut s:
1.
Press the button corresponding to the Input;
2.
Press, in sequence, the buttons corresponding to the Outputs;
3.
Press ENTER to con rm the operation.
4 .
To cancel the operation anytime, press the CLEAR button.
To sw it c h an Inp ut t o all O ut p ut s:
1.
Press the button corresponding to the Input;
2.
Press the ALL button;
3.
Press ENTER to con rm the operation.
4 .
To cancel the operation anytime, press the CLEAR button.
To c all an EDID Preset :
1.
Press the EDID button;
2.
Press the button corresponding to the Input for which the new EDID will be associated;
3.
Use the lower buttons and to navigate between the available EDID presets in the display;
4 .
Press ENTER to con rm the operation. The buttons will blink 3 times if the operation succeed;
5.
To cancel the operation, press the CLEAR button.
To co p y t he EDID f ro m a co nnec t ed d isp lay :
1.
Press and hold the EDID button for 3 seconds;
2.
Press the button corresponding to the Input for which the new EDID will be associated;
3.
Press the button corresponding to the Output from which the EDID will be copied;
4 .
Press ENTER to con rm the operation. The buttons will blink 3 times if the operation succeed;
5.
To cancel the operation, press the CLEAR button.
To c hec k t he d ev ice st at us:
1.
Press and hold the ENTER button for 3 seconds, until the display enters in Status Check mode;
2.
Use the top layer and buttons to navigate between the status screens;
3.
Use the top layer and buttons to navigate between inputs and output numbers.