PL Lite Series
User Manual
- 21 -
Network cables and power cables of all series are connected by aviation connector, as
showed un pictures above:
Note: The connecting cables between the cabinets should pass through the cabinets as
much as possible. If the connection method changed, please set the same connection
method in the software settings. Please refer to the software for more details.
Operation steps:
1) Load capacity of main power cable and main network cable
2) Checking
After the cabinet wiring is completed, use a multimeter to measure whether there is a
short circuit between the AC input (L / N / PE) and DC output (VCC / GND) of the power
supply. If so, please check the circuit carefully. Please make sure the circuit is normal
before starting up. To avoid the entire screen being burned due to the wrong working
voltage, please pay attention to the working voltage range of the cabinet during use.
3) Turn on screen and check the effect
Play high-definition content after starting up, such as video, text, images, etc. It is
suggested to make sure the resolution of the content is in consistent with that of the
screen, otherwise the content will be compressed, thus affecting the overall performance.
4) For software operation, please refer to the software instruction manual.
Under different cabinet sizes and different input voltages, there are differences in the
number of cabinets that wires are able to carry. See the following table for details:
Using
environment
Cabinet
dimension
Product model
Number of cabinets
under 220V
voltage
Number of
cabinets under
110V voltage
Outdoor
500×500
PL3.9W Lite
17
8
PL4.8W Lite
20
10
500×1000
PL3.9W XL Lite
8
4
PL4.8W XL Lite
10
5
Indoor
500×500
PL2.5 Lite
20
10
PL2.9 Lite
24
12
PL3.9 Lite
24
12
500×1000
PL3.9 XL Lite
12
6
Cube
PL2.5 Lite
20
10
PL2.9 Lite
24
12
PL3.9 Lite
24
12
Outdoor
PL3.9W Lite
17
8
Please calculate the resolution according to each box pixel and connect the signal line
according to the load range of the sending card. No more than 655360 pixels can be
loaded on each network port.
