Absco Industries
Assembly Instruction Manual
ABSCO GABLE CARPORT
MODEL: GCPSN2
3.0mW x 6.0mD x 2.66mH
Model: GCPSN2
8/6/23
15
1.
Take a
050
sheet and using a
straight edge, mark the angled
line and carefully cut using tin
snips.
TIP: This cut edge will be
covered by barge flashing.
2.
You’ll have two pieces.
That’s the sheets done for the
right side of a gable end.
Repeat the last steps, with the
angle going the other way, to
make the two left sheets.
3.
Repeat steps until you have
enough pieces to sheet the front
and rear of the carport. 8 sheets
total.
Fitting sheets to framing.
Start with the centre-most sheets
and align the straight edge with
the bottom of the truss.
Every second pan fasten using a
hex head tek screw. Make sure
to
not
use the neoprene washers
here.
Avoid screw placement too close
to existing truss screws. These
can distort the sheeting.
GABLE SHEETS
250
250
120
380
