Part number 20068, Rev 0
5
STARTING
There are no compressor shipping bolts to loosen or valves to open. All that is necessary after
the unit has been properly leveled is to plug the service cord into an electrical outlet When
starting this new appliance, allow the cabinet to operate a minimum of four hours or until it has
started cycling normally before placing product in the cabinet. The motor compressor may
start and stop several times when the unit is first started or after defrosting, especially if the
weather is very hot. This is normal. The motor compressor will cycle normally as soon as the
excess heat has been removed.
TEMPERATURE CONTROL
NOTE: The control is preset at the factory to provide the desired air and product
temperatures inside of the unit and requires no further adjustment. Please
contact the manufacturer’s Technical Service Department before making any
adjustments to determine if adjustment is necessary and, if so, to make sure it is
performed properly.
This unit has an electronic temperature controller located on the front panel above the door.
This controller controls the compressor. Operation of this controller is described starting on
page 7 of this manual.
