*AVAILABLE ON AMBER & RED MODELS ONLY.
Recommend Operation Environment
Ambient Temperature: -30 to 50
Relative Humidity: 10 to 85%, non-condensing
8-16VDC
IP68
INPUT VOLTAGE
MODEL NUMBERS
WATER PROOF
# FIESTA R12
# FIESTA O13
FIESTA - O13
FIESTA - R12
844.9.ABRAMS
WWW.ABRAMSMFG.COM
MODEL: FIESTA R12
MODEL: FIESTA O13
INSTALLATION AND CONFIGURATION MANUAL
ABRAMS
FIESTA TAIL LIGHT
WARNING:
FAILURE TO INSTALL OR USE THIS PRODUCT ACCORDING TO MANUFACTURER’S RECOMMENDATIONS MAY RESULT IN PROPERTY
DAMAGE, SERIOUS INJURY, AND/OR DEATH.
IMPORTANT:
PLEASE READ ALL OF THE FOLLOWING INSTRUCTIONS BEFORE INSTALLING YOUR NEW ABRAMS TRAILER TAIL LIGHT.
• PROPER INSTALLATION OF THIS PRODUCT REQUIRES THE INSTALLER TO
HAVE A GOOD UNDERSTANDING OF AUTOMOTIVE ELECTRONICS, SYSTEMS
AND PROCEDURES.
• THIS PRODUCT CONTAINS HIGH-INTENSITY LEDS. DO NOT STARE DIRECTLY
INTO THESE LIGHTS. MOMENTARY BLINDNESS AND/OR EYE DAMAGE COULD
RESULT.
• DO NOT INSTALL THIS PRODUCT OR ROUTE ANY WIRES IN THE DEPLOYMENT
AREA OF YOUR AIR BAG. EQUIPMENT MOUNTED OR LOCATED IN THE AIR
BAG DEPLOYMENT AREA WILL DAMAGE OR REDUCE THE EFFECTIVENESS
OF THE AIR BAG, OR BECOME A PROJECTILE THAT COULD CAUSE SERIOUS
PERSONAL INJURY OR DEATH. REFER TO YOUR VEHICLE OWNER MANUAL
FOR THE AIR BAG DEPLOYMENT AREA. THE USER/INSTALLER ASSUMES FULL
RESPONSIBILITY TO DETERMINE PROPER MOUNTING LOCATION, BASED ON
PROVIDING ULTIMATE SAFETY TO ALL PASSENGERS INSIDE THE VEHICLE.
• IF MOUNTING THIS PRODUCT REQUIRES DRILLING HOLES, THE INSTALLER
MUST BE SURE THAT NO VEHICLE COMPONENTS OR OTHER VITAL PARTS
COULD BE DAMAGED BY THE DRILLING PROCESS. CHECK BOTH SIDES OF THE
MOUNTING SURFACE BEFORE DRILLING BEGINS. ALSO DE-BURR ANY HOLES
AND REMOVE ANY METAL SHARDS OR REMNANTS. INSTALL GROMMETS INTO
ALL WIRE PASSAGE HOLES.
• INSPECT AND OPERATE THIS PRODUCT REGULARLY TO CONFIRM ITS
PROPER OPERATION AND MOUNTING CONDITION. DO NOT USE A PRESSURE
WASHER TO CLEAN THIS PRODUCT.
• FOR THIS PRODUCT TO OPERATE AT OPTIMUM EFFICIENCY, A GOOD
ELECTRICAL CONNECTION TO CHASSIS GROUND MUST BE MADE. THE
RECOMMENDED PROCEDURE REQUIRES THE PRODUCT GROUND WIRE TO
BE CONNECTED DIRECTLY TO THE NEGATIVE(-) BATTERY POST.
• IT IS RECOMMENDED THAT THESE INSTRUCTIONS BE STORED IN A SAFE
PLACE AND REFERRED TO WHEN PERFORMING MAINTENANCE AND/OR
REINSTALLATION OF THIS PRODUCT.
• FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS
COULD RESULT IN DAMAGE TO THE PRODUCT OR VEHICLE AND/OR SERIOUS
INJURY TO YOU AND YOUR PASSENGERS!
• IF THIS PRODUCT USES A REMOTE DEVICE TO ACTIVATE OR CONTROL THIS
PRODUCT, MAKE SURE THAT THIS CONTROL IS LOCATED IN AN AREA THAT
ALLOWS BOTH THE VEHICLE AND THE CONTROL TO BE OPERATED SAFELY IN
ANY DRIVING CONDITION.
• DO NOT ATTEMPT TO ACTIVATE OR CONTROL THIS DEVICE IN A HAZARDOUS
DRIVING SITUATION.
PACKAGE CONTENTS:
Trailer Tail Light
4 Pin AMP Connector
Rubber Grommet
Product Manual
BLACK* – TAIL LIGHT
BLUE – REVERSE LIGHT
RED
–
TURN/BRAKE/REVERSE LIGHT
WHITE
–
GROUND (-)