Abov AT3108U, Быстрый старт, Страница: 18 / 31

3. Building and running project AT3108U Demo board quick start guide
18
3.4.5 Register value settings
For the register value settings, we provide two methods: Part 1 and Part 2. Using the Part 1, you can
mark check boxes or write values to set the registers. Using the Part 2, you can write I2C commands
directly to set the registers.
1. Part 1:
A. C lick on the ‘Refresh’ button to read the register values currently set in the Touch Sensor
chip. This will update the registers.
B. When you finish changing the settings, p ress the ‘Write’ button to complete the change.
You can see the changes in the ‘Register window’ as s hown in Figure 17.
Figure 17. Register Value Settings (Part1)