A31G213CLN Shield Board Quick Start Guide
3. Building and running project (Shield Board)
11
3.2
Set up the Starter Kit and Shield Board
3.2.1
Set jumpers to control the Starter Kit
1.
The Starter Kit uses USB power-
①
A.
Choose 3.3V and 5.0V (check the maximum operation voltage by referring to the
specification sheet).
2.
External Power-
②
3.
Boot mode selection-
③
A.
Open : User Program operation mode(As a default mode)
B.
Short : Boot operation mode(Debugger always enabled)
4.
MCU RXD0
PC TXD Connection-
④
5.
LED Control (PE0~PE5) -
⑤
6.
Reset(S1), GPIO Input(PF6) -
⑥
Figure 9. Starter Kit Jumper and Switch
