The belt is
running to
the right
1. Turn the left screw clockwise or the right screw anticlockwise
by half turn using the Allen key. Start the WalkSlim Mini Walk
670 to check the new position of the belt.
2. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
3. After adjusting the belt to the middle, start the WalkSlim Mini
Walk 670, set to the maximum speed and observe the tread
belt to ensure that is running smoothly. If it’s not centralised,
then repeat the adjustment steps again.
The belt is
skidding
Turn the left and right screw half a turn clockwise at the same
time and then repeat the adjustment until running normally. Do
not tighten the screw excessively.
Error Messages
E0
Power Supply Issue
Unplug the WalkSlim Mini Walk 670, leave for
several minutes and then restart. If it does not
restart please contact our Customer Service
Centre.
E02
Motor fan is damaged /
motor is overheating
Turn the power off, unplug and leave for one
hour then restart. If it does not restart please
contact our Customer Service Centre.
E05
Weight is overloaded
Follow instructions for the maximum weight
limit (110kgs) and do not overload.
Running belt is too dry
Add lubricant into the underside of the tread
belt (Please refer to the instructions on page
7 of this manual)
The motor is wearing
out
Please contact our Customer Service Centre.
E06
High Current Detected
Add lubricant into the underside of the tread
belt (Please refer to the instructions on page
7 of this manual).
EN
14
