Abode ADSM5001, Руководство пользователя

Страница: 16 / 23

Problem Solving
PROBLEM
POSSIBLE PROBLEM POSSIBLE SOLUTION
The mop is not
working/steaming
1. The power button has
not been pressed. 1. Press the power button on the centre of the steam
mop. This should illuminate the power indicator light.
Ensure you have waited 40 seconds for the water to heat
up – this should allow the second indicator light to
illuminate green
2. Water tank may not be
filled. 2. Make sure the water tank is filled. Refer to page 8 of
the instruction manual provided.
3. The unit may not be
plugged in properly/the
fuse or breaker may not
be working. 3. Verify the unit is plugged into an approved electrical
outlet, is switched on and that the fuse or breaker is
functioning properly.
4. The steam trigger has
not been pulled. 4. You will need to pull the steam trigger under the handle
for steam to begin emitting.
5. The filter had become
blocked. 5. If the filter has become blocked you will need a
replacement filter.
Indicator lights
1. What do the indicator
lights mean? 1. The light on the left illuminates blue when the mop is
plugged in and power button is pressed. When the blue
light has been on and the water has heated sufficiently,
after around 40 seconds, the light on the right should
illuminate green, indicating it is steam ready.
The mop is leaving the
floor streaky
1. The solution has not
been diluted. 1. The solution tank needs to have 5 parts water to 1 part
refresher in. The recommended amount is 30ml Abode
refresher with 150ml water.
The steam mop is
leaking
1. The water/solution
tanks have not been
tipped over a sink/have
been overfilled. 1. When filling the tanks, screw the lids on securely and tip
the tanks upside over the sink to enable water from the lid
to drain. Avoid overfilling the tanks.
2. The steam mop has
been held over one area
for too long. 2. Do not leave the steam mop concentrated over one
area for more than a couple of seconds. This could
damage your floor and may cause small puddles of water
to leak.
3. The water has not
heated sufficiently. 3. You need to let the water heat up in the tanks for at
least 60 seconds before pulling the steam trigger. Make
sure the power is switched on.
Using refreshers
1. What can I use
refreshers on? 1. You can only use refresher solution on sealed hard
floors. Do not use on carpets, this can cause damage. If
you are unsure, contact the manufacturer.
2. How do I use the
refresher solution? 2. Fill the tank and set the dial on the front of the mop to
“open” to start using the refresher on sealed hard floors.
16