C
H A L K B O A R D
UCW2000
V.1.00 Mar/1/2005 95E-0000-003
5
After you use pen scrolling without tapping for some time, you may find the pen to suddenly stop functioning. Just
tap on any surface to “wake up” the pen out of standby mode.
H
OLDING THE
P
EN
V
ERTICALLY
When drawing pictures or signing your name, try to hold the pen vertically for best results.
U
SING BOTH A
P
EN AND AN ORDINARY
M
OUSE
You may have both a chalkboard and an ordinary mouse installed on the same computer. You can switch between
the two devices at will and, in fact, you can switch between the digital pen, and an ordinary mouse whenever you want.
A chalkboard with USB interface does not conflict with an ordinary mouse in these ways, though
U
SING A
P
EN WITHOUT AN ORDINARY
M
OUSE
You may work with the chalkboard only, without an ordinary mouse at all. When you remove an ordinary mouse,
make sure you also completely remove its driver
. You remove the mouse driver by selecting Start > Settings >
Control Panel > Device Manager, press the “+” sign to reveal the mouse driver, select and remove it, and restart the
computer.
COMMON PROBLEMS AND SOLUTIONS
(1) The LED light does not come on at all.
Make sure all connections are made properly so that power is supplied, and data signals can be transmitted. For a
digital pen, lightly tap the pen tip on any surface and try again. For the chalkboard mouse, press the left button. If
the light still does not come on, check the battery in the pen or the chalkboard mouse. If the battery is OK, seek
help from your reseller.
(2) The cursor does not move with pen movement after installation.
Verify that the hardware functions properly, and check the presence of the icon (
) in the
system tray
(lower
right corner of screen) to verify that the chalkboard driver has been loaded. If the icon does not appear, remove
and re-install the driver
(3) No matter how hard you press on the pen tip, the line does not become thicker.
Test the pen’s pressure sensitivity as described before in this guide.
(4) The cursor moves erratically or jitters when the pen is held still.
Keep the chalkboard at least 5-inch (12 cm) away from a monitor, modem, and other electronic devices, because
certain devices may emit electromagnetic interference.
(5) The digital pen stops functioning after a period of intermittent operation.
This may be caused by the rare occasion of the battery running out. To change the battery, remove the back
cover, and replace the used battery with a fresh one.
F C C WA R N I N G
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
