Ablerex ATS-16A, Руководство пользователя, Страница: 17 / 24

16
3.4.3. Boot up
Once input power is connected, the ATS automatically boots up. The LCD
display during boot is as shown in Figure 5 and all LEDs ( , , )
are lit. LCD display is as shown in Figure 6 after boot up, only the LEDs for
Power A ( ) and Power B ( ) are lit.
Figure 5 Figure 6
3.4.4. Switch input source
This products supports manual switching between power supplies as instructed
below:
Push and hold the button for 2 seconds until you hear two short beeps.
The system then needs to reconfirm the power transfer (LCD display as shown
in Figure 7), so push and hold the button for 2 seconds to confirm. The
system will switch to the other input (LCD display as shown in Figure 8) if the
power supply is normal, otherwise the transfer is not made and a warning is
shown (LCD display as shown in Figure 9).
Figure 7 Figure 8 Figure 9