Mode selection:
X
X
X
1
Double height mode
X
X
1
X
Double width mode
X
1
X
X
Graphics mode
1
X
X
X
Inverted (reversed)
0
0
0
0
Default
B0
B1
B2
B3
Print Mode
Any combination of modes is permissible.
The command <ESC><126> stores the current character set and print mode (double height, etc) in
the EEPROM and these will be the default setting the next time the printer is powered on or reset. If
this code is not received the Ap25 reverts to previous default values on the next power up.
<ESC><ESC>
(Print any buffer contents, and) Print Self test message.
<ESC><127><n>
(Print any buffer contents, and) Select country character set.
<ESC><126>
(Print any buffer contents, and) Store country character set and print mode
in EEPROM.
<ESC><125>
(Print any buffer contents, and) Clear the EEPROM.
<CR>
Print any buffer contents (line terminator). Treat as <CR><LF>.
<LF>
Print any buffer contents (line terminator). Treat as <CR><LF>.
<CR><LF>
Print any buffer contents (line terminator). Treat as single <CR><LF>.
<LF><CR>
Print any buffer contents (line terminator). Treat as single <CR><LF>.
A character line is automatically terminated and printed if it reaches the full line width for a given
mechanism and print mode setting. Note that if any of the above 4 line terminator codes is received
immediately after a character which completes a printable line, it will be ignored.
This treatment differs from the Ap24 family but will generally be an improvement.
<VTAB>
Print any buffer contents, and feed 30 dot lines.
If the print quality deteriorates due to dot lines being displaced, the EEPROM can be cleared and the
chip forced to repeat the first-time initialisation by sending the code <ESC><125>.
/Attachment: Appendix 1(EMC Directive 89/336/EC Disclaimer)
(Operator information)
(Ap25 Dimensions)
Ap25 Users’ Guide Page 6 of 8