Albert-Büttner-Straße 11
D-91207 Lauf / Pegnitz
Tel. +49 (0) 9123 188-0
Fax +49 (0) 9123 188-188
[email protected]
www.abl.de
ABL SURSUM
Bayerische Elektrozubehör GmbH & Co. KG
eMH3
WALLBOX
Quick start guide, version 03/2017, Article no. 0301471_b
EN
Operating status display – RFID module
The two LEDs on the upper part of the housing cover of model variants 3W14A2 and 3W22A2 indicate the current operating status of the internal RFID module of
the wallbox. During normal operation, the following operating states are shown:
DESCRIPTION
The RFID module is ready for use, a charging process may be requested at any time using an access card.
Green LED flashes every 5 sec., blue LED is off
The RFID module has read the access card and initiated authentication.
Green LED flashes, blue LED is off
Authentication of the access card was successful, access to the charging process is being granted.
Green LED is lit for one second, blue LED is off
Authentication of the access card was NOT successful, access to the charging process is NOT being granted.
Green LED is off, blue LED is illuminated
Charging procedure
Please follow the following steps to charge your vehicle:
1.
Check the LED indicators on the housing cover of the eMH3: When the wallbox is ready for operation,
the green LED charging indicator in the lower part of the housing cover will flash, while the blue LED is
off.
For model variants 3W14A2 and 3W22A2: If access control via the RFID module is enabled, the blue LED
will flash every 5 seconds, while the green LED is off.
The vehicle may now be connected.
Green LED is off, blue LED flashes every 5 sec.
2.
Open the charging socket on the vehicle.
3.
Connect the Mode 3 charging cable to one of the charging sockets on the wallbox.
4.
Plug the charging connector of the charging cable (Type 2 or Type 1) into the vehicle’s charging socket.
5.
The green LED
is illuminated permanently when the vehicle is connected and has been detected but
the charging procedure has not yet been unblocked by the vehicle.
6.
For model variants 3W14A2 and 3W22A2, log in at the RFID module of the eMH3 using a suitable access card. To do this, hold the card in front of the
RFID symbol on the upper part of the housing cover.
7.
The green LED on the RFID module will begin flashing while the card is checked and will remain on for 1
second as soon as login has been accepted or the card has been refused.
Green LED flashes, blue LED is off
Green LED is ON for one second, blue LED is off
8.
The green charging LED goes out and the blue LED is ON permanently when the vehicle is connect-
ed and the charging procedure has been unblocked: In this state, the wallbox is waiting for the vehicle to
initiate the charging procedure.
9.
Charging is completed when the blue LED
is flashing. When charging is complete, unplug the cable
from the vehicle socket and from the socket of the wallbox.
The charging procedure can be manually interrupted at the vehicle and is automatically terminated by
the vehicle when charging is complete.
