110406_ABI-EV1002_QSG_ML.doc
English
Page
5
N.V.
abitana
S.A.
ENGLISH
ABI-EV1002S00
Twisted Pair Broadband
Distribution Amplifier
Quick Start Guide
1
Package Contents
•
DIN rail mountable Broadband Amplifier module
•
Quick Start Guide
•
3
Termination
plugs
ABI-AP1003S00
•
Power jumper cord ABI-PS1001SPC
2 Tools
•
Level
tester
ABI-TT1003S12
•
Spanner
11mm
•
Flat screw driver max. 5mm x 0.6mm
3 Introduction
The ABI-EV1002S00 is a Broadband Amplifier with one coaxial
input for CATV signal or antenna.
The unit has 4 independent RJ45 (Twisted Pair) outputs on the
front.
For ease of installation, a Power Level indicator is provided,
indicating the safe area of operation for optimal transmission and
quality results.
A range of Twisted Pair to Coax adapters (with or without
adjustment, filters,…) is available for installation at the receiver
end (i.e. ABI-AC1001S00*).
It is possible to connect a Radio by using a Radio adapter (ABI-
AC1004S00) or an adaptor without filter.
4 Connectors
P1
P2
P3
POWER
P4
Input to CATV signa l
or Antenna
Outputs to 4 indepent
TV Sets
Power Adjustment
Grounding wire
ABI-EV1002S00
Power level a djustment
(ABI-AC1001S00)
5 Power
Load ratio for this module = 0,5.
Maximum allowed load ratio (sum of the load ratios for all modules) for
power supply ABI-PS1001S11 = 4.
6 Installation
Power Off the central
ABI-PS1001S11
Power Supply by means of the
Circuit Breaker installed in the ‘
Comm Center Cabinet
’, or by
removing the mains power cord from the Power Supply.
1.
Make sure the shielding of the Network Interface Unit (NIU)
or CATV transition point is properly connected to the
protective ground.
2.
Open the ‘Comm Center Cabinet’
3.
Click the ABI-EV1002S00 unit on the metal DIN-rail.
4. The ABI-EV1002S00 is supplied with a grounding wire,
connected to the input F-connector.
This wire (1) must be connected to the protective ground of
the installation.
The following system devices also need to be connected to
the protective ground: The DIN-Rail frame (2) and the Power
supply (3)
EV1002
Power
Supply
DIN-Rail Frame
PE1002
1
2
3
4
DC1015
5. Provide power to the module using the included power
jumper cord ABI-PS1001SPC. Please consult the manual of
the power supply for more information concerning the
installation of the power supply.
6.
Connect a coax cable from the CATV connection point (NIU)
or the CATV transition point to the coax connector on the top
of the unit.
.
Failing to follow the instructions (1) to (6) in the specified order
may lead to permanent damage of the ABI-EV1002S00 amplifier
When it is impossible to connect the DIN rails ,frame or CATV
transition point to ground, make sure they are at least at the same
electrical level (connected to each other).
