
2-14 Chapter 2
3.
Slide the clip (A) on each support toward the processor , exposing the
hole that will fit the peg on the motherboard . Push the latches (B) on the
processor toward the center of the processor until they click into place.
4.
Hold the processor so that the fan shroud is facing toward the pegs on
the motherboard. Slide the processor ( Direction C ) into the retention
mechanism and press evenly and gently. Ensure that the pegs on the
motherboard slide into the holes on the heat sink support and that the
alignment notch in the processor fits over the plug in Slot 1 .
Содержание AB-LM6
