Abit AB-AT6, Руководство пользователя

Страница: 46 / 84

3-24 Chapter 3
On board IDE-1 Controller:
Onboard PCI IDE 1 controller can be set as Enable or Disable.
/
Master drive Mode:
ä
Auto: the BIOS can auto-detect the transfer mode of the HDD in
order to set its data transfer rate. (Default)
ä
PIO Mode 0 ~ 4: User can specify the PIO mode of the HDD in
order to set its data transfer rate.
/
Slave drive Mode:
ä
Auto: the BIOS can auto-detect the transfer mode of the HDD in
order to set its data transfer rate. (Default)
ä
PIO Mode 0 ~ 4: User can specify the PIO mode of the HDD in
order to set its data transfer rate.
On board IDE-2 Controller:
The onboard IDE-2 controller can be set at Enable of Disable.
/
Master drive Mode:
ä
Auto: the BIOS can auto-detect the transfer mode of the HDD
installed in order to set its data transfer rate. (Default)
ä
PIO Mode 0 ~ 4: User can specify the PIO mode of the HDD in
order to set its data transfer rate.
/
Slave drive Mode:
ä
Auto: the BIOS can auto-detect the transfer mode of the HDD
installed in order to set its data transfer rate. (Default)
ä
PIO Mode 0 ~ 4: User can specify the PIO mode of the HDD in
order to set its data transfer rate.
PIO MODE 0~4 reflects the HDD data transfer rate. The
higher the MODE value is, the better is the HDD data transfer
rate. But it does not mean that you can select the highest
MODE value just as you like, you first have to be sure that
your HDD supports this MODE, otherwise the hard disk will
not be able to operate normally.
2
For further information about HDD installation, refer to Appendix B.