Abisal UBS01, Инструкция по эксплуатации

Страница: 13 / 33

EN
Programs
1. Start: When machine stop, this button will start the engine as the preset model
2. Program: When machine stop, this button can preset four modes as below:
Manual: Led shows HA.00, this mode can set time between 0 and 20
minutes. When you press start button, you can adjust the speed as your needs.
But time can not work.
Automatic P1:
Led shows P1.01, this mode will run at a certain rhythm.
Time and speed.
Cannot work.
Automatic P2: Led shows P2.03, this mode will run at a certain rhythm.
Time and Speed Cannot work.
Automatic P3: Led shows P2.05, this mode will run at a certain rhythm.
Time ans speed cannot work.
3. Power: You can make the machine standby after you turn on and press this
button. Then led will show ‘’_ _ _”. While you press again it will resume to
norm.
Also when you switch on and not use it for 3 minutes, it will go into standby.
4. Time/Speed+: When machine stop in manual mode, time can be increased
between 1-20 minutes (Default time: 10 minutes).
While machine works in manual mode, speed can be raised by this button.
5. Time/Speed-: When machine stop in manual mode, time can be reduced
between 1-20 minutes (Default time: 10 minutes).
While machine works in manual mode, speed can be down by this button.