1) Mount the tonearm base to turntable plinth
1-a) Define the place where arm base should be placed by using the arm template supplied.
1-b) Put the hole of the template into the center spindle. Use an attached marking pin supplied (as
illustrated below) and put it through the arm hole center on the template of the other end.
Keep the needle perpendicular to the template and mark the position of center on the turntable.
1-c) At the same time 3 holes for fixing screws should be marked.
1-d) Having marked the center, check that if the tone arm is placed in this position it will clear the
lid.
1-e) Drill the a 22mm hole and three 3.5mm hole.
* Drilling a hole: 22mm diameter (For tonearm shaft)
* Drilling 3 x 3.5mm diameter (For tonearm base fixing screws)
2) Attach the cartridge to headshell
2-a) Connect the lead to cartridge and attach the cartridge to the correct position of headshell with
screws. (See the figure)
* Screws are not included in this tone arm kit
3) Mount TA-1 shaft through the base hole
3-a) Locate the tonearm shaft through the hole in the arm base and then fasten the screw with
wrench.
3-b) Adjust the arm height as turn table plinth surface and tonearm wand should be leveling.
* Cueing platform has already been set at the correct height but can be adjusted by using the
wrench supplied.
Template
Arm base
Turntable plinth
φ22mm
Template
Arm base
Marking pin