Abilitec Amber, Начало работы

Страница: 15 / 21

Infra-red Programming
Now that each of the labels has been recorded, we are ready to program the infra-red
codes for the devices Amber will control.
1. Take your television infra-red remote control transmitter and place it
on a flat surface, pointing towards the small window labelled TEACH
on Amber’s rear panel.
Leave a gap of approximately 5 cm between the transmitter (remote) and the rear
panel (TEACH). Make sure the remote is level with the window. Sometimes you
may need to place the remote or Amber on a book to achieve correct alignment.
2. Switch the COMMAND switch on the rear panel to MULTI.
This switch should already be in the MULTI position from previous recording.
3. Press the LEARN button.
The yellow LEARN light will come on.
4. Press the SELECT button, hold for one second, then release.
You will hear the Heading “Television” play.
5. After the word “Television” has played, press the SELECT button
momentarily.
You will hear the word “on” play.
6. After hearing the word “on” press and hold the SELECT button.
7. While holding the SELECT button, press and hold the ON button on
the television remote control.
If your television remote does not have a separate “on” button, use the “Channel 1”
button instead (assuming that this will turn the television on).
Remember to keep the remote control facing the TEACH window. The LEARN light
should flash for about one or two seconds and then go out. The green CORRECT
light should come on indicating that the teaching was successful.
8. Release the SELECT button.
The next word in the list will play.
9. Repeat steps 6,7 & 8 until Amber has learned all the commands
under the word “Television”.
This process can be repeated with your other remote controls for the commands under
the other Headings (e.g. Video, Stereo).