Abilia Gewa BigJack IR-6SP, Инструкция по эксплуатации

Страница: 21 / 52

21
4. Press and release the button X on BigJack on which the IR channel is to
be placed. The red and green indicator lamp now lights with a steady light.
5. Press and hold down the button
Y
on the remote control unit that is to be
taught to BigJack. Release it when the red indicator lamp goes out. This
may take as long as 10 seconds. If the red indicator lamp returns to a red
light, press again one or several times until both red and green indicator
lamps go out.
If the indicator lamp flashes red and a sound signal is heard
, the
teaching process has failed. Repeat the process from step 4.
6. Conclude the process by pressing button
6
.
7. If the teaching process has succeeded for the first button, continue with
the next button as described above in points 3-6 until all IR channels are
programmed.
Hint! BigJack can learn IR channels from most remote control units on the
market, but there are a few exceptions. It may affect certain functions or it
may affect all of the functions on a remote control unit. It is possible in these
cases to use another teaching mode. Replace step 3 above by the following
procedure: press in
P
and
1
at the same time and hold them depressed for
about 2 seconds until the green indicator lamp flashes and then goes out.
The unit is now in a different learning mode. Continue with the procedure
described above.
Recording IR channels
P
+
1
, select button on BigJack
X
, select button on standard remote
control
Y
, then continue or finish with 6 .