ABICOR xFUME AF500, Руководство по эксплуатации

Страница: 10 / 16

EN - 10
5 Putting into operation xFUME
®
ABIROB
®
AF500
5.1 Setting up the torch neck
1
Screw the replaceable tip adapter
(D)
onto the torch neck
(G)
using the multi-wrench
(J)
.
2
Screw the contact tip (B) into the tip adapter (D) and tighten using the multi-wrench (J) .
3
Grease the torch neck O-rings.
4
Insert the torch neck (G) into the connection module (H) until reaching the stop.
5
Screw the bayonet nut
(F)
onto the connection module
(H)
locking the 3 pins in place.
6
Insert the fume tube (E) into the bayonet nut (F) until reaching the stop.
7
Screw the suction nozzle
(C)
into the fume tube
(E)
hand tight.
8
Screw the gas nozzle (A) onto the tip adapter (D) hand tight.
5.2 Setting up the cable assembly
► Select the correct wire type and appropriate wire guide for your application.
► For information on cutting the wire to size and correctly assembling the wire guide, see the following
section:
 8 Maintenance and cleaning on page EN - 12
Fig. 3 Setting up the torch neck
A
Gas nozzle
B Contact tip
C
Suction nozzle
D Tip adapter
E
Fume tube
F
Bayonet nut
G Torch neck
H
Connection module
I Key
J
Multi-wrench
A
I
B C D E F G H
J
Tab. 7 Liner type
Steel and stainless steels Spiral liners
Aluminum, copper, nickel and stainless steels
PA liners