Abicor Binzel xFUME FLEX, Руководство по эксплуатации, Страница: 40 / 92

EN - 18
BAL.0733.0 • 2021-01-11
9 Maintenance and cleaning xFUME FLEX
9.2 Pre-filter
The pre-filter consists of the following components:
The pre-filter cannot be cleaned; it must be completely replaced. The filter pad (2) is the most important element. When
replaced regularly, the service life of the primary filter is prolonged.
9.2.1 Replacing the filter pad
1 Spring clamp 2 Filter pad 3 Filter grill
Fig. 7 Pre-filter
1
2
3
Figure Action

Fig. 5 on page EN-15 1 Switch off the welding fume extraction system at
the On/Off switch
(4) .
Without 2 Pull out the mains plug.
Without 3 Unlock and open the service door using a square
wrench.
4 Remove the pre-filter.

Fig. 7 on page EN-18 5 Remove the spring clamp (1) and filter pad (2) .
Without 6 Dispose of the filter pad (2) in accordance with local
regulations.

12 Disposal on page EN-23
Without 7 Insert the new filter pad.
Without 8 Insert the spring.
9 Insert the pre-filter in xFUME FLEX.
Without 10 Close the service door and lock it using a square wrench.
Tab. 8 Replacing the filter pad