MB EVO PRO/MB EVO
5 Operational controls on the handle
EN
-
29
4
Re-connect the return hose to the coolant recirculator.
4.5
Connecting the shielding gas
• Select the appropriate shielding gas for the welding task at hand.
• Briefly open the gas supply valve and close it again to blow out any
contamination at the connector.
• Connect the shielding gas to the welding device according to the
manufacturer's instructions.
• Adjust and set the amount of shielding gas for the gas nozzle in use and
welding task at hand.
4.6
Feed in wire
1
Cut off a small piece of the start of the wire with a cutter to remove
any burrs.
2
Insert the wire in the wire feeder according to the manufacturer's
instructions.
3
Press the button to switch off power to the wire feeder until the wire exits
the contact tip.
4
Cut off any protruding wire.
5 Operational controls on the handle
The button's two-cycle operating mode is available for the standard welding
torch.
Additional operating modes and handle modules depend on the power
source and must be purchased separately.
5.1
Button with two-cycle function, fig. C
1
Press and hold button on handle = start welding.
2
Release the button = end welding.
6 Operation
1
Open the shielding gas cylinder, switch on the power source.
2
Set the welding parameters
3
Start welding.
7 Decommissioning
1
End welding.
2
Wait until the shielding gas post-flow time has passed and switch off the
power supply.
3
Close the shielding gas cylinder valve.
8 Maintenance and cleaning
8.1
Replacing wear parts, fig. F
• The torch neck can be fitted with various wear parts depending on the
welding task at hand.
• The gas nozzle and retaining spring are inserted.
• All other wear parts are screwed on.
CAUTION
Risk of injury
Puncture or cut-in wounds may be caused by the wire electrode.
• Keep your hands out of the danger zone and wear the correct protective gloves.
NOTICE
• Consult the documentation for the welding components.
NOTICE
• Liquid-cooled cable assemblies leak if overheated. Therefore, allow the cooling unit to continue to run approximately 5 minutes after welding.
DANGER
Risk of injury due to unexpected start
Turn off the entire system prior to assembling, disassembling or servicing parts of the device.
• Close all supply lines.
• Disconnect the electrical power supply.
WARNING
Risk of burns
The welding torches reach very high temperatures during welding.
• Allow the welding torches to cool down and wear the correct protective gloves.
Содержание MB EVO PRO
Страница 14: ...BG 14 5 MB EVO PRO MB EVO 3 4 4 5 4 6 1 2 3 4 5 2 5 1 2 C 1 2 6 1 2 3 7 1 2 3 8 8 1 F 5...
Страница 67: ...MB EVO PRO MB EVO 2 JA 67 2 3 2 4 MAC UV 2 5 2 6 2 7 4 2 8...
Страница 143: ...MB EVO PRO MB EVO 2 ZH 143 2 3 2 4 MAK 2 5 2 6 2 7 2 8...
Страница 145: ...MB EVO PRO MB EVO 4 ZH 145 4 4 1 1 2 4 2 MIG MAG 8 ZH 146 4 3 A 1 2 3 ABICOR BINZEL BTC 4 4 B 1 2 3 4 4 5 4 6 1 2 3 4...
