iFEED 742
5 Transport and installation
EN
-
11
The wire feeder feeds the welding wire and regulates the wire speed. All the valves required for gas and
compressed air have been installed in the housing.
4.2 Technical data
5 Transport and installation
Tab. 1
Ambient conditions for transport and storage
1
1 According to EN IEC 60974-1
Ambient temperature
−10°C to +60°C
Relative humidity
20% to 80% (non-condensing)
Tab. 2
Ambient conditions for operation
1
1 According to EN IEC 60974-1
Ambient temperature
+10°C to +40°C
Relative humidity
20% to 80% (non-condensing)
Tab. 3
General information
Supply voltage
DC 42 V
Motor amperage
2.8 A
Number of wire feed rollers/wire pressure
rollers
4
Welding wire diameter, steel
0.8 mm to 1.6 mm
Welding wire diameter, aluminum
1.0 mm to 1.6 mm
Feeding speed
1.5 m/min. to 22 m/min.
Dimensions (L × W × H)
305 mm × 190 mm × 264 mm
Weight
5.9 kg
WARNING
Risk of injury due to improper transport and installation
Improper transport and installation can cause the device to tip or fall over. This may result in serious
injuries.
► Check and wear your personal protective equipment.
► Place the device on a suitable base (flat, solid, dry) on which it will not topple over.
► Do not place the device on a power source. If necessary, use an appropriate holder.
► Note the weight of the device when lifting it.