Abicor Binzel iCOOL 1200, Оригинальная инструкция по эксплуатации, Страница: 25 / 60

iCOOL 1200 9 Maintenance and cleaning
EN - 11
9.1 Maintenance and cleaning intervals
The specified intervals are standard values and refer to single-shift operation. When using arc welding
equipment, always observe the provisions of EN 60974-4 Inspection and testing, as well as any national
laws and regulations.
9.2 Changing the coolant
1
Remove the cap on the coolant tank and keep the coolant tank open throughout the entire procedure.
2
Place a receptacle below the device. It must be able to hold at least 5 liters.
3
Connect the discharge hose to the drain coupling.
4
Hang the other end of the drain coupling in the receptacle and wait until no more coolant flows out.
5
Remove the discharge hose and store it in a safe place.
6
Fill the new coolant only up to the MAX line.

6.2 Initial commissioning on page EN - 10
7
Seal the filler neck with the coolant tank cap.
9.3 Replacing the fuse
Daily ► Check coolant level and top up, if necessary.
► Check couplings and grommets for leaks and adjust or replace as
needed.
Monthly ► Blow out the ventilation openings and air head exchanger with
compressed air from the outside and remove all dust.
► Check the coolant supply and return hoses for dirt and debris and
replace if necessary.
Every six months
► Change the coolant.

9.2 Changing the coolant on page EN - 13
► Rinse the coolant tank.
► Flush the coolant circuit with clean water.
► Check external connections for leaks and tighten hose clamps using
pliers as needed.
► Check coolant hoses for damage.
1
Loosen the fuse holder on the back side of the device using
a suitable flathead screwdriver.
2
Remove the fuse holder and fuse.
3
Remove the fuse from the fuse holder.
4
Insert the new fuse.
5
Mount the fuse holder with the new fuse in the device.