Abicor Binzel iCOOL 1200, Оригинальная инструкция по эксплуатации

Страница: 24 / 60

EN - 10
7 Operation iCOOL 1200
7 Operation
7.1 Prior to initial commissioning and after a longer standstill
1
Bleed the device and cable assembly.
 6.2.2 Bleeding the device on page EN - 10
 6.2.4 Bleeding the cable assembly on page EN - 11
2
Check the tightness of the coolant connections.
8 Decommissioning
► Observe the documentation for the welding components.
1
Set the main switch of the welding power source to <0>.
2
Pull out the mains plug of the welding power source to disconnect from the power supply.
3
Disconnect the coolant supply hose from the coolant supply connector (blue).
4
Disconnect the coolant return hose from the coolant return connector (red).
9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
3
Set the main switch of the welding power source to <I>.
4
Press the <Cooling unit on/off> button on the control panel
of the welding power source.
The LED lights up and the device is ready for operation.
WARNING
Electric shock due to defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Damaged, deformed or worn parts should only be replaced by a qualified electrician.
CAUTION
Risk of injury due to unexpected start
If power is supplied during maintenance, cleaning or disassembly, rotating parts can start running
unexpectedly and lead to injuries from cuts.
► Switch off the device.
► Disconnect all electrical connections.
► Leave the device switched off throughout the entire bleeding process.