Abicor Binzel BRS-LCi, Руководство по эксплуатации

Страница: 29 / 76

BRS-LCi 6 Putting into operation
EN - 11
6.6 Setting up the compressed-air motor
1
Loosen the motor clamping in the guide block
(4)
by removing the screws
(3)
.
2
Pull back the compressed-air motor
(5)
in its mount.
3
Place the required distance sleeve
(7)
on the milling cutter
(6)
.
4
Move the torch with the gas nozzle
(2)
to the clamping position.
5
Keep the guide block
(4)
in the lower position (stroke at bottom).
6
Place the compressed-air motor
(5)
against the gas nozzle
(2)
with the distance sleeve
(7)
placed on
top .
7
Fasten the adjusted motor position by means of the screws
(3)
.
8
Move the torch out of the clamping device and remove the distance sleeve
(7)
from the milling cutter
(6)
.
6.7 Adjusting the proximity switch
1
Loosen the screws
(4)
.
2 Move the retaining sheet (3) vertically in the area of the elongated slot.
3
Adjust the proximity switch
(1)
to the center of the transmitter disc
(2)
.
4 Fasten the retaining sheet (3) by means of screws (4) .
1 Clamping device
2
Gas nozzle
3 Screws
4
Guide block
5 Compressed-air motor
6
Milling cutter
7 Distance sleeve
Fig. 7
Setting up the compressed-air motor
2 1
4
3
5
6
7
NOTE
• Observe the clearance (6-9 mm) between the proximity switch
(1)
and the retaining sheet
(3)
.
• The proximity switch is equipped with an LED for controlling the switching output.
1
Proximity switch
2
Transmitter disc
3
Retaining sheet
4
Screws
5
Screws
Fig. 8 Adjusting the proximity switch
1
4
2
3
6-9mm
5