Abicor Binzel BRS-LCi, Руководство по эксплуатации

Страница: 27 / 76

BRS-LCi 6 Putting into operation
EN - 9
6.1 Installing with support

See Fig. 4 Putting into operation on page EN-9
1 Fasten the support (9) on a vibration-free working surface in the work area of the robot by means of four
screws (8) .
2
Position cleaning station
(3)
with two cylindrical pins
(12)
on the support
(9)
and fix it with four screws
(1)
.
3 Fasten collecting tray (11) to the support (9) by means of two screws (10) .
6.2 Installing without support

See Fig. 4 Putting into operation on page EN-9

See 2.3 Technical Data on page EN-4
1
Position cleaning station
(3)
with two cylindrical pins
(12)
on a vibration-free mounting surface and fix
it with four screws
(1)
.
2 Fasten collecting tray (11) below the motor by means of two screws (10) .
3
Fasten drain of collecting tray
(11)
with a hose (ø= 8mm) to a suitable collecting container. If none is
used, you must seal the drain (thread G 1/8").
4 Fasten bottle holder (7) in the vicinity of the cleaning station.
6.3 Fastening the V-block

See Fig. 4 Putting into operation on page EN-9
1 Screw the V-block (4) into the clamping device (6) from above.
2
Screw in the cylinder screw
(5)
.
1 4 screws M8
2
Complete V-block
3 Cleaning station
4 V-block
5
Cylinder screw M5x200
6 Clamping device
7 Bottle holder
8
4 screws
9 Support
10 2screws
11
Collecting tray
12 2 Cylinder bolt
ø
8 mm
Fig. 4
Putting into operation
1 4
5
6
12
11
10
8 9
3
7
2