Abicor Binzel BRS-LC, Инструкция по эксплуатации

Страница: 35 / 84

BRS-LC 7 Transport and installation
BAL.0030 • 2019-01-18
EN - 13
7.6 Setting up the compressed-air motor

also Fig. 4 Putting into operation on page EN-11
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3) .
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the reamer (6) .
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (4) in the lower position (stroke down).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve placed on top (7) .
7 Fasten the adjusted motor position by means of the screws (3) .
8 Move the torch out the clamping device (1) and remove the distance sleeve (7) from the reamer (6) .
NOTICE
• When changing the reamer, only use tools with a suitable width across flats.
Motor protection cap AF 21, reamer AF17.
1 Clamping device
2 Gas nozzle
3 Screws
4 Guide block
5 Compressed-air motor
6 reamer
7 Distance sleeve
Fig. 8 Setting up the compressed-air motor
1 2
3
4 5
6
7