Abicor Binzel ABICAR ADVANCED 42V, Оригинальная инструкция по эксплуатации

Страница: 44 / 108

EN - 16
6 Putting into operation ABICAR ADVANCED 42V
6.3 Positioning guide arms
In order to ensure restricted guidance along the contact surface, the guide arm (E) must be adjusted so that
it is shorter than the guide arm (B) . The adjustment depends on the direction of movement and the length of
the guide arm. The difference should be approx. 10 mm for a straight component.
1
Loosen the knurled screw (C) and advance by 10 mm or one groove.
2
Retighten the knurled screw (C) .
6.4 Positioning the welding torch
The cross slide must be adjusted according to the welding torch type and diameter. The welding torch
position can be changed in the vertical and horizontal direction during welding using the cross slide.
► Turn the adjusting screws
(A)
and
(C)
of the cross slide to the left or right.
The brackets (B) and (D) can be adjusted sidewise, or downwards and upwards.
Fig. 7
Adjustment of restricted guidance
A
Component
B Guide arm, rear
C
Knurled screws
D
Angle of approach
E Guide arm, front
Contact surface of the component
Travel direction
A
B
C
D
E
C
Fig. 8 Adjusting the cross slide
A
Adjusting screw, vertical
B Bracket, horizontal
C
Adjusting screw, horizontal
D Bracket, vertical
A
D
C
B