Abicor Binzel ABICAR 1200 PRO, Оригинальная инструкция по эксплуатации

Страница: 47 / 124

ABICAR 1200 PRO 42V 6 Putting into operation
EN - 17
To achieve the correct form of oscillation, the axis of the oscillator’s output shaft and that of the welding torch
must cross.
6
Adjusting the welding torch.
6.4 Positioning guide arms
In order to ensure restricted guidance along the contact surface, the rear guide arm (E) must be adjusted so
that it is shorter than the front guide arm (B) . The adjustment depends on the direction of movement and the
length of the guide arm. The difference should be approx. 10 mm for a straight contact surface.
1
Loosen the knurled screws (C) and advance by 10 mm or one groove.
2
Retighten the knurled screws (C) .
Fig. 9
Adjusting the welding torch
Fig. 10 Adjustment of restricted guidance
A Component
B
Guide arm, front
C Knurled screws
D Angle of approach
E
Guide arm, rear
Contact surface of the component
Travel direction
A B
C
D
C
E