Abicor Binzel ABI-CAR E-1200, Инструкция по эксплуатации

Страница: 50 / 68

EN - 18
BAL.0647.0 • 2018-08-24
6 Commissioning ABI-CAR E-1200 / E-1200-O
6.4 Mounting the welding torch
The position of the welding torch can be adjusted during operation.

Step 1 , Fig. 14 on page EN-20
* Fig. 11 is illustrative. ABI-CAR E-1200 is shown. Discrepancies are possible.
1 Insert the welding torch (4) into the welding torch fixture and secure it by manually tightening the handwheel (3) .
2 Set the desired angle (Fig. 12, pos. C) and right-left position (Fig. 12, pos. B) of the welding torch by loosening the hand
lever
(1) , (2) and manually angling the welding torch. Then tighten the hand lever (1) , (2) again.
3 Set the desired angle (Fig. 12, pos. A) of the welding torch to the part to be welded by loosening the hexagon socket
screw
(5) and manually turning the welding torch. Then tighten the cylinder head screw (5) again.
CAUTION
Mechanical damage
Damage to the welding torch due to excessive tightening of the handwheel (3) .
• Tighten the handwheel (3) by hand to secure the welding torch.
1 Hand lever 1 (adjustment of tilt angle and right-left position)
2 Hand lever 2 (adjustment of tilt angle and right-left position)
3 Handwheel
4 Welding torch
5 Hexagon socket screw
(not shown, differs from illustration)
Fig. 11 Mounting the welding torch*