background image

DO NOT use cream
cleaners or bleach.
These substances are
abrasive.

Regularly clean with
mild liquid detergent
or soap and water.

DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.

INSTALLATION GUIDE 

Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with the standards in your 
respective countr y and must be adhered to by your licensed tradesperson.

Step 1: 

 Find a structural member within the wall being mounted to (timber stud, concrete wall, timber block)

Step 2: 

 Install the female brackets onto the wall spread evenly to balance the mirrors weight, screws should 

be a minimum of 10 gauge to ensure shear strength, ensure that the screw is installed tightly and has 
penetrated a structural material.

Step 3: 

Check that the brackets are installed level with eachother

Step 4:

 Install the male brackets onto the mirror and ensure that the location of the female and male 

brackets align perfectly. Ensure you do not use screws too long when fixing the male brackets as this could 
penetrate the mirror. We recommend using 12mm timber screws

Step 5: 

Engage a qualified electrician to wire into the driver which is located and pre-fitted into the back of 

the mirror

Step 6:

 Once wired, it can be mounted by lifting the mirror whilst aligning the male and female brackets, this 

does not require glue if brackets are installed correctly.

INSTALLATION MANUAL

BEFORE YOU START

- Contact a qualified tradesmen for installation of this mirror
- Contact a qualified electrician for the wiring installation of this mirror

FEMALE BRACKETS

MALE BRACKETS

Отзывы: