DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.
INSTALLATION GUIDE
This product must be installed by a licensed plumber.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with AS/NZS 3500.
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors that are
involved that can alter the installation method.
INSTALLATION GUIDE
1
Check the desired height of basin from floor.
2
Fit waste and trap to basin.
3
Hold basin against wall aligning outlet of
trap with waste pipe. Extend telescopic trap
up or down to find desired height & cut waste
to suit trap.
4
max 450mm C’s
structure in wall
If correct height and position is suitable, level
the top of the basin & mark out desired position.
Drill 15mm holes through the back of basin with a wood
drill bit at maximum 450mm centres. Fix basin into
structural support in wall.
5
Secure plumbing to basin and wall outlet.
Test by running water through the waste.
Place the cover plate over drain. Silicone
top and sides of basin if necessary.
IN THE
BO
X
2 x Wall plug
2 x M8 Hanger bolt
2 x Plastic washer
2 x Metal washer
2 x Nut
1 x Basin
level
