Please read fully and understand Setup Guide prior to operating the TR3!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐
www.abiattachments.com
Page
7
of
17
Attaching and Setting up your TR3 Rake:
*NOTE: Ensure the Draw Bar on the Tractor is pushed in before hooking up the TR3 to the Tow Vehicle. Make
sure the bottom 3 point arms are set to the same length, and that the Tractor sway bars are fully locked on the
bottom 3 point arms prior to operation.
#1
#1
#2
Step 1
– Attach the tractor to the lower arms
indicated by arrow #1 in the picture. There are two
connecting holes on the TR3 for the bottom arms of
the tractor to attach to. If the TR3 is connected to
the bottom holes, then make sure to connect the
Top Link in the bottom holes on the mast shown by
the arrow labeled #2. If the lower arms of the
tractor are connected to the TR3 in the top hole,
connect the Top Link using the top hole as well. The
Top Link is shown in Fig. 1.
**Some models of Tractors may vary on top link
location. The top link should sit as level as possible
when the TR3 is operational.
Fig. 1 – Top Link
Step 2
– Make sure that the Scarifiers are pinned in
the first hole or above on top of the Scarifier Tube
for the setup process. The Scarifier tube has 4 holes
in it, allowing the Scarifier’s to be adjusted to the
depth desired for ripping with the TR3. For setup
purposes the Scarifier’s should be pinned up, so
that the TR3 can be properly leveled; without the
Scarifier’s hindering any adjustments.
