Initial Setup
Step 1:
Step 2:
Step 3:
Step 4:
Remove the plastic wrap from your Rascal. The best way to
do this is by using a utility knife and to cut around the base
of the skid. Use caution not to cut the banding and be sure
to stand off to the side in case any items have come loose
during shipping.
Make sure the delivery driver stays while you remove the
plastic so you can verify all parts are present and there is
no damage. If there is any damage make sure to mark it on
the bill of lading.
Verify that all parts are there such as profile blade and the
hitch/tongue. These components will be strapped to the
frame of the tool.
Please also verify that all optional equipment is present.
In the picture you will see how the optional railblade
comes mounted to the Rascal. After verifying that all your
parts are accounted for you can let the delivery person go
on their way.
Next you will cut the banding that straps the Rascal to the
pallet. Please be cautious when cutting the banding. Cut
the center bands first and then work your way outward,
keeping your body out of the way due to the possibility of
falling parts.
Locate the hitch bar sent with the Rascal. The
hitch bar will go into the slotted end of the tongue
assembly. Remove the two bolts and nuts already
installed on the tongue assembly. Slide the hitch
bar into place as far as possible. If it does not lineup
properly you can insert a punch or 3/8” ratchet
extension and tap it down into place, then insert the
bolts and nuts and tighten them down.
Call Toll Free:
877-788-7253
Email:
5