Abex Exhibit Systems • 355 Parkside Drive, San Fernando, CA 91340 • (800) 537-0231
PAGE 1
Tighten both screw firmly.
Loosen the screws on base plate but
do not remove them. Than swivel
base plates.
Bottom view
Bottom view
Z965 - Corner Connector
Z967 - Straight Connector
NOTE: Remove connectors
from beams before packing
NOTE: Remove corner connectors
from exrtrusions before packing
Connect frame spliced extrusions
together, as shown, using Torx tool
(included). Do not overtighten.
Connect frame extrusions together,
as shown, using Torx tool
(included). Do not overtighten.
001
001
002
003
005
004
Z965 - Corner Connector (2)
006
007
Power Supply
Wire Managment Hole
Z967 - Straight Connector (2)
Z967 - Straight Connector
Z961/13 - Tension Lock
NOTE: Remove connectors
from beams before packing
Connect frame spliced extrusions
together, as shown, using Torx tool
(included). Do not overtighten.
Tension Lock
Torx Tool
Place tension lock into groove.
Insert Torx 30 wrench and turn
1/2 turn
Slide straight connector (Z967) into inner channel of
extrusion.Turn screw enough to hold connector in place.
Take another extrusion and slide onto straight connector. Tigthen
both screws to connect extrusions together.
Repeat above steps to connect all spliced extrusions together.
Slide corner connector (Z966) into both sides of horizontal
extrusions.Turn each screw enough to hold connector in place.
Slide vertical extrusions onto corner connectors of top horizontal
extrusion. Turn each screw enough to hold connector in place.
Finish frame assembly by sliding corner connectors of bottom
horizontal extrusion into inner channel of vertical extrusions and
tighten the screws to secure frame extrusions together.
Z967 - Straight Connector
008
009
Wire Managment
Z961/13 - Tension Lock
Z961/13 - Tension Lock
011
010
001
Wire Managment
012
025
026
013
027
LIGHTS DETAILS
Lights come attached to extrusions. Ensure all lighting strips are connected.
Once frame is assembled, connect strip-to-power cords to the end of top
and bottom lights chain.
- For bottom lights connect strip-to-power cord to power supply directly.
- For top lights connect extension cord to strip-to-power cord and run with
wire managment extrusion then connect to power supply.
Run AC power cord out through grommet hole on vertical upright and
connect to power outlet.
T o remove or re-attach light strips use provided thumbscrews with plate.
Strip-To-Power Cord
EXtension Cord 12ft
001
001
001
014
015
016
017
019
020
018
021
022
023
024
1.
2.
3.
4.
5.
6.
Power Supply
