Abel BS001, Руководство пользователя

Страница: 6 / 8

OPERATING PROCEDURE
Plug the splitter into a single phase 15 amp plug point and switch on.
Press the START button on the control box.
The chain will immediately start, and will continue to run until the limit switch, which sits
near the back of the blade, is activated.
Once the limit switch is activated, the chain will stop, reverse briefly to remove the next brick
in line, and stop.
The bottom blade will then move up, split the brick, move back to its bottom position and stop.
The split bricks will slide out through the side chutes, clear the limit switch, and the process
will repeat itself.
The splitter will go into sleep mode if not active for a couple of minutes.
The start button must be pressed again to reactivate the splitter and start the chain.
The splitter is fitted with an overload device.
Should it happen that a foreign object jams in between the blades, and it cannot complete its
cycle, the splitter will stop, reverse to the bottom and wait for the object to be removed.
Once removed it can be started again