6
IDEAL 4107; IDEAL 4109
2.2 Power supply
The name plate is located at the rear of the
machine.
- Data stated on the name plate
- Voltage “ V “,
- Frequency “Hz”,
- Power consumption “A”
must correspond to the values of the power
supply unit.
-
Earth wire must be available.
- Connect the machine to the mains.
2.3 Checking rotating direction
Operate the machine for a short time as described
under 3. “Operation“..
- The material is transported to the shredding
mechanism by a conveyor belt.
Warning!
Switch off the machine immediately at the
main switch if the conveyor belt runs in the
opposite direction.
When the conveyor belt runs in the opposite
direction:
The machine is wired according to the IEC
standardized rotary field. When changing the rotary
direction we recommend that this is performed by
an experienced specialist. The rotary direction is
changed by exchanging the “L1“ and “L2“
connections in the plug.
Danger!
Incorrect exchanging of connections may
endanger the operator. If in doubt, this work
should be performed by an electrical
specialist.
1-800-658-8788 - www.abcoffice.com
