Abbott & Ashby Linisher Installation Manual
11
10. Installation
STEPS ONLY REQUIRED FOR INSTALLING ABBOTT & ASHBY AA362 LINISHING
ATTACHMENT TO AN EXISTING BENCH GRINDER
Remove the grinding wheel and guard off the side of the bench grinder
that you would like to install the linishing attachment to. Keep the
original nut and washer holding the grinding wheel in place
Install the Main Bracket (A) to the
Grinder, using the 3 x 6x20mm locking
fasteners (I)
Place the Drive Pulley (H) onto the
shaft of the bench grinder if it is a
16mm dia shaft. If the bench grinder
has a smaller 12mm shaft you will
need to insert the bush (not pictured)
to the shaft and then place the drive
pully onto the shaft to ensure there is a
snug fit.
Place the washer (K) over the shaft
onto the drive pulley
