ABB XT7, Руководство по эксплуатации и обслуживанию

Страница: 43 / 193

ABB | SACE Tmax XT
Ekip Touch - Interface and menus | 6 - PIN and security 41 | © 2020 ABB | 1SDH001821A1002 - ECN000135670
6 - PIN and security
Safety
WARNING! the user is responsible for security against unauthorized access and
modification: configure all Trip unit access points (display menu and, if present,
Ekip Connect and remote communication systems) using the access PIN and controlled
and authorized connection systems
Function The PIN code enables access to certain areas of the Trip unit and prevents unintentional setting errors from
being entered via the display.
However, parameters can still be modified without having to enter the PIN via:
• service connector, using Ekip T&P or Ekip Programming and the Ekip Connect application
• bus, in the presence of Ekip Com modules and with Trip unit configured as Remote (page 128).
To ensure your unit is in secure conditions, the Wizard window immediate asks you to change the PIN code
on first power up; this is strongly recommended by ABB (page 17).
Description The PIN code is a number formed by five digits, each of which can be given a value from 0 to 9; the default
value is:
00001 and can be changed in the Settings - New PIN menu.
The PIN code must be entered to:
• change a parameter (including the PIN code itself)
• access the
Test menu
Once the PIN code has been entered, all menus can be browsed for two minutes: once two minutes have
elapsed, the PIN code must be entered again (depending on the case in question).
NOTE: the PIN code must also be entered again if a programming session has been annulled
(page
39
).
Entry
The following page will appear when the PIN code is requested: change ( 1 ) and confirm ( 2 ) each digit to
complete the entry process.
Figure 26
NOTE:
• if the PIN is wrong, “Wrong PIN” will appear for three seconds after which the entry page will
be displayed again; use the command at the top left to quit
• there is no limit to the number of wrong PIN that can be entered
Disabling The PIN code can be disabled by entering its value as: 00000; In this case, the PIN is only required to change
the PIN itself in the
Settings menu.
Recovery
if the PIN code is lost, consult document 1SDH001501r1002 , available in the ABB website, or contact ABB
directly.