ABB XT7, Руководство по эксплуатации и обслуживанию

Страница: 188 / 193

ABB | SACE Tmax XT
186 | © 2020 ABB | 1SDH001821A1002 - ECN000135670 Other electronic accessories | 2 - Ekip Signalling Modbus TCP
Other electronic accessories
1 - Ekip Signalling 10K
Ekip Signalling 10K
is an external accessory signaling module. It can be installed on a standard 35 mm DIN
rail (DIN EN 50022 type TS 35x15 mm).
This module has:
• Ten programmable output contacts
• Ten or eleven programmable digital inputs
• One power led and twenty or twenty-one signaling leds (one for each input/output)
The module can be set in four different configurations
• One in case of connection to a Link bus network
• Three configurations in case of connection via Local Bus (to allow up to three modules to be connected
to the same trip unit)
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further details about
Ekip Signalling 10K are available in ABB Library, especially in document
1SDH001318r0002 .
IMPORTANT: make sure that you have read the recommendations concerning safety
and prevention of unauthorized access.
2 - Ekip Signalling Modbus TCP
Ekip Signalling Modbus TCP is an external accessory module. It can be installed on a standard 35 mm DIN
rail (DIN EN 50022 type TS 35 x 15 mm).
Its function is to share on another Ethernet network with communication protocol.
The module has 11 digital inputs and 10 output contacts:
• The inputs allow the state of the devices and other information to be monitored
• The outputs allow the circuit-breakers to be operated.
Each input and output is associated with a state LED.
The module can function in three different modes:
Mode Characteristics
CB Supervisor
The module can be associated with a single circuit-breaker, which can be
selected from a list. Configuration of the inputs and output is pre-defined
Multi MCCB Supervisor
The module can be associated with up to five circuit-breakers. Configuration of
the inputs and output is pre-defined.
NOTE: mode available with moulded-case circuit-breakers
Free I/O The inputs and outputs can be fully configured by the user
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further details about
Ekip Signalling Modbus TCP are available in ABB Library, especially in document
1SDH001456r0002
.