2106123MNAD | WI-FI ANTENNA KIT | 5
Attach the right angle SMA fitting of the cable to the board
ANT-1, connector (J42).
Figure 3: Attach at ANT-1
Attach the plug-to-jack
adapter to the straight SMA
fitting of the cable.
Figure 4: Attach the straight
SMA fitting
Attach the surge protector
to the plug-to-jack adapter.
Figure 5: Attach the surge
protector
Figure 4:
Figure 5:
Cut the ground cable to length. Strip
⅜
inch of insulation from
the free end.
IMPORTANT NOTE:
The ground cable is attached to the ground
post located near the enclosure’s door. Allow enough length for a
service loop of approximately 1 inch from the surge protector to
the ground post.
Remove the crimp ring terminal from the surge protector. (See
number 1 in the following photo).
