![background image](http://html.mh-extra.com/html/abb/sace-tmax-xt5/sace-tmax-xt5_operation-and-maintenance-manual_2240196.webp)
ABB | SACE Tmax XT
194 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Internal accessories | 8 - Ekip Signalling 1K
8 - Ekip Signalling 1K
Ekip Signalling 1K
is a signaling accessory allowing programmable inputs/outputs to be managed.
The module can be configured in the CB with the IEC standard.
IMPORTANT: each circuit-breaker can house one module only; configuration with
external modules is not allowed if an internal module is present
Connections
The circuit diagrams and references concerning the terminals are available in document
To connect the module to Ekip Touch and to actuator MOE-E if present, please consult document
.
Power supply
Ekip Signalling 1K
is supplied directly by the Ekip Touch to which it is connected.
WARNING! communication between Ekip Touch and the module is interrupted in the
absence of auxiliary power supply
Input
The input can be configured so that its status corresponds to actions or signals, with different programming
options (see
Menu
).
The module permits two logic statuses, interpreted differently by the Trip unit on the basis of the selected
configuration:
State
Electrical condition
Contact configuration
Status detected by
Trip unit
Open
Circuit open
Active open
ON
Active closed
OFF
Close
Short-circuit
Active open
OFF
Active closed
ON
Output
The output has three contacts: normally open (NO), normally closed (NC) and common.
The output can be configured so that the contacts change status when one or more events occur, with
different programming options (see
Menu
).
Compared to the common contact, the NO and NC contacts have the following electrical characteristics:
Characteristics
Maximum limit
(1)
Maximum switchable voltage
150 VDC / 250 VAC.
Breaking capacity
2 A @ 30 VDC, 0,8 A @ 50 VDC, 0,2 A @ 150 VDC,
4A @ 250 VAC
Dielectric strength between contact and internal coil 1000 V AC (1 minute @ 50 Hz).
(1)
data relating to a resistive load
Содержание SACE Tmax XT5
Страница 2: ...ABB SACE Tmax XT 2 2019 ABB 1SDH002039A1002 ECN000093027 Rev A ...
Страница 4: ...II 2019 ABB SACE Tmax XT 1SDH002039A1002 ECN000093027 Rev A ...
Страница 204: ...ABB SACE Tmax XT 202 2019 ABB 1SDH002039A1002 ECN000093027 Rev A Other accessories 5 Testing and Programming ...
Страница 205: ...1SDH002039A1002 ECN000093027 Rev A ...