ABB PST30, Руководство по установке и пусконаладке

Страница: 47 / 200

Connection
Chapter 5
47
1SFC132003M0201
5:2.2 Supply voltage and control circuit
When used for marine applications, and if feeding from the
outside of the enclosure, then please use a standard cable
for feeding the supply voltage and for the control circuit, with
an auxiliary bare conductor (earth conductor) and make a
360 degree connection to earth in the glands, or close to the
glands. As long as these cables / wires are only internal
wiring, inside the enclosure, there is no need for the 360
degree earth connections / protections.
5:2.2.1 Supply voltage, terminals 1 and 2
Connect neutral and phase to terminal 1 and 2.
Check that you have the correct supply voltage U
s
.
5:2.2.2 Earthing, terminal 3
Connect the cable to a earthing point close to the softstarter.
The cable should be as short as possible. A suitable earthing
point would be next to the softstarter on the mounting plate,
see Figure 8. The mounting plate should also be earthed.
This is not a protective earth, it is a function earth . The
earthing cable should be as short as possible. Maximum
length 0.5 m.
Figure 9: Tightening torques and cable dimensions (1 mm=0.0394 in)
1
100-250V
Stop
Start
In0
In1
Vc
50/60 Hz
2
3 4
5
6
7
8
1SFC132051F0001
Figure 7: Supply voltage
1
100-250V
Stop
Star
t In0
In1
Vc
50/60
Hz
2
3
4 5
6
7
8
1SFC132052F0001
Figure 8: Function earth
M3
1. . . . . . . . . . . . . . . . . . . . . . . . 20
0,5 Nm - 4,3 lb.in
3,5x0,6
0,14 ... 2,5 mm
AWG 12 ... 22
0,14 ... 2,5 mm
2
2
1SFC132053F0001