15
6.2
Battery Pack Replacement
The totaliser display is maintained for approximately one
minute after removal of power to enable the battery pack to be
changed. The count is typically stored for a further 2 to 3
minutes after which time a random totaliser value is displayed
on restoration of power.
The battery pack must be replaced annually on systems using
the 15 minute measurement interval in intermittent mode and
proportionally more often for other measurement intervals.
Caution. Ensure that the battery connector
locking ring is not cross-threaded and tighten connector
firmly by hand.
6
OPERATION
For full details of operation and displays refer to the
AquaProbe Transmitter Configuration Manual (IM/AQUAPB-
CM).
6.1
Start-up and Operation – Fig. 6.1
Ensure connections have been made correctly, connect power
and follow the sequence of operation detailed in Fig. 6.1. To
change between continuous and intermittent mode refer to the
AquaProbe Transmitter Configuration Manual.
Connect
Power
Connect
Power
Continuous display
of flow measurement
Display indicates version
number for
≈
1 sec (IP00)
Display Blank
Continuous
Mode
Intermittent
Mode
Apply operating wand
to area marked 'ACTIVATE'
on the transmitter
for < 3 seconds
Apply operating wand
to area marked 'ACTIVATE'
on the transmitter
for > 3 seconds
Displays current flow
measurement for preset
time interval
Displays last flow
measurement
End
Transmitter
Display
1.234
✶
Note. If the AquaProbe Transmitter is not connected
the flowrate display may flash or show random values.
Fig. 6.1 AquaProbe Operation
Содержание Kent-Taylor AquaProbe
Страница 22: ...20 NOTES ...