ABB IMASI13, Инструкция по эксплуатации

Страница: 101 / 128

6 - 6 WBPEEUI240766B0
Error Messages and Corrective Actions
error block. For example, if byte four contains a 10 and byte
five contains a 42, then block 1042 contains the error.
For more information on module status, refer to the appropri-
ate controller instruction.
Error Example
FC 215 for the ASI module and 216 for the active channel need
the same address. Check that the address on ASI switch S1;
the address in FC 215, specification S1; and FC 216, specifica-
tion S1 are the same.
If the module address in FC 216 is not the same as in FC 215,
the controller will enter error mode when attempting to go to
execute mode. The error will indicate five, (byte three of mod-
ule status/error message equal to 05) configuration error -
undefined input.
Modify the address in FC 215 and the associated FC 216
blocks. The ASI address value set in FC 215, specification S1
and FC 216, specification S1 should match the ASI module
address set on S1.
Use a human system interface to change the configuration
data. For procedures on how to change a function code specifi-
cation, refer to the appropriate instruction for the human sys-
tem interface being used.
The controller generates a local I/O error in the module status
if the I/O expander bus is not connected between the ASI mod-
ule and the controller. Verify that the bus is connected on the
MMU backplane.
NOTE: Setting FC 215, specification S4 to zero will cause the controller to trip
when the IMASI13 module fails. Changing specification S4 to a one causes the
controller to
continue to operate if the IMASI13 fails or is missing.
If both the FCs 215 and 216 have the wrong address, the con-
troller status will indicate a local I/O error. To correct this:
1. Remove the ASI module and change the setting of S1 to
match the controller configuration settings.
2. Refer to Section 3 for information on setting an address
and installing an ASI module.