HVC-R 107/160 V2 E-BUS CHARGER - USER MANUAL
D OCU MEN T N O.: 9AK K108467A663 5-EN V0.3 | DATE: 20/ 1 2/2022 PAGE
11
OF
20
4. The charger will automatically start to charge the vehicle after the preparation phase, and will
indicate the progress by the LED state (see in figure 3).
Stop charging:
5. The charge session will automatically stop after completing the bulk charge mode (standard
setting is 99% SOC for this setup but this can be customized).
6. The charge session can also be stopped manually by either pushing the stop button on the
Depot Charge Box GEN2 or the stop button on the bus (not available on every bus).
7. Charging stops
8. The connector is unlocked by the vehicle for CCS when the Depot Charge Box GEN2 beacon
light changes color to green
9. Take the connector out of the vehicle and put it back in the connector holder on the Depot
Charge Box GEN2.
3.2
Charging with 2, 3 or 4 Depot Charge Boxes GEN2
The main principle of the sequential charging is to complete the bulk charge for all the buses that are
connected to the charger, before they leave the depot in the morning. The sequence will be based on
the principle first come, first serve.
Start charging:
1. Park the electric vehicle with the charge inlet within reach of the connector.
2. Turn off the electric vehicle.
3. Connect the charger’s connector to the vehicle’s charge inlet.
4. When there is no other bus already connected that requires bulk charging:
•
The charger will automatically start to charge the vehicle after the preparation phase,
and will indicate the progress by the LED state (see figure 3).
5. When there is another bus already connected that is being charged:
•
The LED state will turn to green and start blinking until the other charge sessions are
complete. After completing the other charge session(s) the charger will automatically
start to charge the vehicle after the preparation phase, and will indicate the progress
by the LED state (see figure 3).
Stop charging:
6. The charge session will automatically stop after completing the bulk charge mode (standard
setting is 95% SOC for this setup but this can be customized).
7. If there is another bus connected to the charger that requires bulk charging the charger will
stop the session and automatically switch to the next bus in line.
8. The charge session can also be stopped manually by either pushing the stop button on the
Depot Charge Box GEN2 or the stop button on the bus (not available on every bus).
9. If the stop button is pressed and there is another vehicle connected that requires bulk charg-
ing, the charging will automatically switch to the next bus in line.
10. When the charging is stopped automatically or by pressing the stop button, the connector is
unlocked by the vehicle for CCS.
11. Take the connector out of the vehicle and put it back in the connector holder on the Depot
Charge Box GEN2.
NOTICE
Session end
Charging will stop without user interaction:
•
When the EV indicates to the charger that charging is
completed.
•
When the charger completed the bulk charge.
If the battery is not full, a new charge session can be started.