ABB HT593673, Руководство по эксплуатации

Страница: 74 / 108

Operation Manual / 4 Product description / TPS44-H.. - TPS52-H..
8 Eliminating malfunctions / 8.4 Malfunctions when stopping
© Copyright 2017 ABB. All rights reserved. HZTL4037_EN Revision E July 2017
8.4 Malfunctions when stopping
Runout noises
Possible causes Remedy
Turbocharger Turbocharger contaminated Clean (see chapter Periodic maintenance work → 30 )
Bearing damaged Check clearances (see chapter Axial clearance A and
radial clearance B → 59 ). If clearances are outside
the tolerance or if in doubt, contact an ABB Tur-
bocharging Service Station.
Rotor rubbing Check clearances (see chapter Radial clearances N
and R → 67 ). If clearances are outside the tolerance
or if in doubt, contact an ABB Turbocharging Ser-
vice Station.
Foreign object in the tur-
bocharger Dismantle turbocharger (see chapter Dismantling
and fitting → 46 ). In case of damage, replace the
corresponding parts or contact an ABB Turbochar-
ging Service Station.
Table 25: Malfunctions when stopping – Runout noises
Runout time too short
The runout time must be noted down as a reference. Because the runout time depends on
the oil viscosity, the runout time must always be measured at the same oil temperature.
If the runout time is significantly shorter in comparison to a previous measurement, the fol-
lowing table must be observed.
Possible causes Remedy
Turbocharger Turbocharger contaminated Clean (see chapter Periodic maintenance work → 30 )
Bearing damaged Check clearances (see chapter Axial clearance A and
radial clearance B → 59 ). If clearances are outside
the tolerance or if in doubt, contact an ABB Tur-
bocharging Service Station.
Rotor rubbing Check clearances (see chapter Radial clearances N
and R → 67 ). If clearances are outside the tolerance
or if in doubt, contact an ABB Turbocharging Ser-
vice Station.
Foreign object in the tur-
bocharger Dismantle turbocharger (see chapter Dismantling
and fitting → 46 ). In case of damage, replace the
corresponding parts or contact an ABB Turbochar-
ging Service Station.
Table 26: Malfunctions when stopping – Runout time too short
Page
44
/
77