Quick guide - FIO-01
3
• Insert the module carefully into the option slot on the control
board until the retaining clips lock the module into position.
• Fasten the screw (included) to the stand-off.
Note:
Correct installation of the screw is essential for fulfilling the
EMC requirements and for proper operation of the module.
Terminal designations
Wiring
Maximum cable size is 1.5 mm
2
(AWG 16) for digital signals and
2.5 mm
2
(AWG 14) for relays. The cable shields should be
connected to the JCU-01 Control Unit. See the drive
Hardware
Manual
for more information.
Tightening torque is 0.3 N·m (2.7 lbf·in) for the digital I/O plugs
and 0.5 N·m (4.4 lbf·in) for the relay plugs.
Programming
The communication between the module and the drive is activated
by a drive parameter. See the drive
Firmware Manual
.
Marking
Description
X61, X62, X63,
X64
•
DIOx
= Digital I/O. Input (default), push-pull or
open collector. Selection is made by parameter.
See the drive firmware manual for more
information.
•
COM
= Ground reference on option board
1
DIOx
2
COM
X65, X66
•
ROxNO
= Relay normally open
•
COM
= Common
•
ROxNC
= Relay normally
connected
1
ROxNO
Re
la
y x
2
ROxCOM
3
ROxNC